Separate names with a comma.
Discussion in 'Call Of Duty 13 : World War II' started by TxTnT, Nov 25, 2017.
I haven't played COD WWII MP much, but when I do, I always come out in last place.
As always as far I know you.
no that's me ....lol
There was a number of things that were bugging me about the game , a bit of lag and I tried a few things I found on youtube to make it better, since then I get less lag and higher fps, cause unlike TxT we can't all have the latest and greatest graphics card
Also I didn't realise as a pre-order I had an unlock token that meant I could unlock the bar ahead of earning it by ranking up, only realised then I saw the amount of people with it at low ranks.
Oh, put a cork in it, tonto.
Hmm.............my card is 3 years old
2old u play WW II? Add me as friend TxTnT
I sure will -- if I can figure it out lol
Follow the vids when you get it up otherwise you may end up getting frustrated. Add Txt then add me from his friends list
Well I will be back when I get a reply on what to do on my MOBO. Wont boot hangs in bios. I got extented warranty and it should be covered I hate changing MOBO's. Well at least I wont have to reinstall everything,well I didnt last time when surge got everything. Fingers crossed.
Boy that was quick! sooo here I go.
¿ Both power connectors, JPWR1 (24 Pin) & JPWR2 (4 Pin/8 Pin, for CPU Power) must be attached to this model to ensure operation of the Mainboard. ¿ A Power Supply of 500 watts, or above, is highly recommended for system stability. ¿ ATX 12V power connection should be 20A or greater. Please try with clearing the cmos setting on Jbat1 jumper/SW1 Switch or removing the battery on the mb out for 1 minute and put it back in with power off. Please test out the mb and components outside the case with mb box to support the board. This can prevent any short or grounding problem to the mb and the components. Try with swapping other components like the processor/memory/power supply/video card with other working system components to limit down and defective components installed into the system board. Remove all connection/installation of add on cards, drives, and extra cable connection from the mb. Try with bare minimum components installed only. If all steps have been tried and problem still persists then please kindly refer to our website for manufacturer warranty RMA info/request: http://service.msicomputer.com/msi_user/rmaform_p.aspx
Wow hope it all goes well and you don't have to send it off
got a RMA will do it nxt week
2old whats ur name in WW II?